How Much Does a Concrete Slab Cost in Florida?
One national cost guide puts a concrete slab in Florida at about $5.90 to $6.60 per square foot in 2026. Across the country, a new slab runs about $4 to $8 per square foot. The average poured slab costs about $5,400. A 100-square-foot shed pad can start near $600, and a 2,000-square-foot home foundation can reach about $36,900.
These are market numbers, not our price list. Superior Concrete and Construction pours concrete slabs, pads and foundations across Marion County and about 50 miles around Ocala. Your own price depends on the size, the thickness, the ground and the site work your slab needs.
What Does a Concrete Slab Cost per Square Foot in Florida?
Cost guides price a slab by the square foot, with labor and materials included. The Florida figure comes from a national cost guide’s table by state, updated in April 2026. The same guide puts the middle of the country near $5.35 per square foot. Coastal states such as California and New York run as high as $8.50.
So Florida sits a little above the middle of the country and well below the top. Labor makes up about one-third to one-half of the total, per the same guide. Cost guides put labor at about $2 to $5 per square foot. That covers building the forms, delivering and mixing the concrete and pouring the slab.
How Much Does Concrete Cost per Yard?
Concrete itself is sold by the cubic yard. A landscaping cost guide, updated in September 2026, puts it at $120 to $150 per cubic yard. That price includes delivery within 20 miles.
One cubic yard covers about 81 square feet of a 4-inch slab, per a national cost guide. So the concrete alone runs about $1.50 to $1.85 per square foot at 4 inches thick. The rest of the installed price goes to the base, the forms, any steel and the labor.
Small orders pay more per yard. The landscaping guide adds about $43 per cubic yard for orders smaller than a full truckload. That fee falls hardest on small pads.
What Does a Concrete Pad Cost by Project?
Cost guides also price slabs by the job. A national cost guide lists these installed prices for common slabs.
| Project | Square feet | Installed cost, national |
|---|---|---|
| Shed pad | 100 to 400 | $600 to $4,800 |
| Patio | 200 to 400 | $1,000 to $6,000 |
| Two-car garage floor | 400 to 576 | $2,400 to $6,900 |
| RV pad | 200 to 700 | $1,200 to $8,400 |
Applied to common sizes, the Florida rate of $5.90 to $6.60 per square foot works out as follows. The concrete column assumes a slab 4 inches thick.
| Slab | Square feet | Concrete at 4 inches | At $5.90 to $6.60 per square foot |
|---|---|---|---|
| 10 x 10 shed pad | 100 | about 1.2 cubic yards | $590 to $660 |
| 12 x 20 pad | 240 | about 3 cubic yards | $1,416 to $1,584 |
| 20 x 20 pad or patio | 400 | about 4.9 cubic yards | $2,360 to $2,640 |
| 24 x 24 garage or shop floor | 576 | about 7.1 cubic yards | $3,398 to $3,802 |
| 30 x 40 barn or shop floor | 1,200 | about 14.8 cubic yards | $7,080 to $7,920 |
The state rate is an average, so treat these as a starting point. Thickness, steel, base work and any tear-out move a real job up or down. An equipment, RV or boat pad is figured the same way: square feet times the rate.
For patio and lanai slabs, see our concrete patios and pool decks page. Our pole barn cost guide covers barn and shop floors and the farm-building exemption.
What Makes One Slab Cost More Than Another?
Thickness comes first. A national cost guide says most slabs are 4 to 6 inches thick, and most shed slabs about 4. Florida’s residential code sets 3.5 inches as the minimum for slab-on-ground floors. A 6-inch slab takes half again as much concrete as a 4-inch slab.
The mix matters too. Florida’s code sets 2,500 psi as the minimum strength for interior slabs, garage floors, porches and carport slabs. A stronger mix costs more, per a national cost guide.
Steel and fibers add cost. Florida’s residential code calls for contraction joints in slab floors. If you accept the risk of random cracking, synthetic fibers or welded wire can contain cracks instead. The code sets fiber at 0.75 to 3.0 pounds per cubic yard.
A slab under heated, enclosed space gets a 6-mil vapor retarder, with joints lapped at least 6 inches. Garages, utility buildings, unheated accessory buildings, carports, driveways, walks and patios do not need one. So a shed pad or patio skips a line item that a house slab carries.
The ground under the slab moves the price as well. Florida’s code skips the 4-inch base course where a slab sits on well-drained sand or sand-gravel soil. Where a gravel base is needed, a national cost guide puts it at $1 to $3 per square foot. Leveling or regrading runs about $0.40 to $2.00 per square foot.
Fill under a slab is capped at 24 inches of clean sand or gravel, unless the building department approves more. Our site prep and grading work covers the pad, the fill and the compaction under a slab.
Access counts too. If the mixer truck cannot reach the slab, crews must move and pour the concrete by hand. A national cost guide says that raises the labor cost.
What Does It Cost to Replace an Old Slab?
Replacing a slab means paying for two jobs: breaking out the old one and pouring the new one. With disposal included, a national cost guide puts concrete removal at $3 to $8 per square foot. Removing a 10 x 10 slab runs about $300 to $800, depending on the job and the rebar inside.
Breaking out and hauling an old slab is part of our concrete removal work. Our concrete driveway cost guide covers driveway tear-out and the county road connection.
What Does a Slab Foundation for a House Cost?
A house foundation is a bigger job with more code steps. A national cost guide puts a slab foundation at $6 to $14 per square foot. That is $12,000 to $28,000 in total on average. Another guide puts a 2,000-square-foot home foundation at about $36,900.
Florida’s code adds steps that a patio skips. New construction needs a preventive termite treatment. A soil treatment goes on inside the foundation after excavation, backfill and compaction are done. The slab under living space also gets the 6-mil vapor retarder.
Do You Need a Permit for a Concrete Slab in Florida?
It depends on the job and where you live. A Florida law now exempts single-family homeowners and their contractors from a building permit for work under $7,500. It does not apply to property partly or entirely in a flood hazard area. It also does not cover electrical, plumbing, structural, mechanical or gas work.
You or your contractor must file a written request with the building department first. The request goes in with the contract or other proof of the job’s value. In Marion County, once an exemption is approved, no after-the-fact building permit will be issued for that work. So decide before the pour whether you will want a permit on record.
Some counties publish their own no-permit lists. Sumter County lists residential concrete flatwork among the items that need no building permit. Check with your building department before work starts. We plan the build around the permit and inspection schedule.
How Do You Get a Real Price for Your Slab?
A real number starts with a look at your site. The size and the thickness set how much concrete goes in. The ground, the base and any old slab to remove set the rest.
Our free on-site estimate spells out the thickness, the reinforcement, the base and the finish for your job. See how we pour concrete slabs, pads and foundations, or call or text (352) 286-7836.